Effect of adjuvants on the amount of air included in droplets generated by spray nozzles

Carregando...
Imagem de Miniatura

Data

2013-12-01

Autores

Mota, Alisson A. B. [UNESP]
Antuniassi, Ulisses R. [UNESP]
Chechetto, Rodolfo G. [UNESP]
Oliveira, Rone B. De
Silva, Anne C. A. E [UNESP]

Título da Revista

ISSN da Revista

Título de Volume

Editor

Associação Brasileira de Engenharia Agrícola (SBEA)

Resumo

The air included in droplets generated by spray nozzles directly int0erferes in transport, deposition and retention of the droplets after its impact on the target. The objective of this study was to analyze the interference of adjuvants in the amount of air included in droplets generated by spray nozzles. The treatments were composed by four spray solutions containing mineral oil, vegetable oil, surfactant and water, and three spray nozzles, two air induction type and one pre-orifice. The air included was calculated by the difference between the volume of spray mix (air plus liquid) and only the liquid, which was made by means of sprayed samples captured in a funnel and collected in a graduated cylinder. The surface tension was estimated by the gravimetric method using a precision scale and a graduated pipette. The surfactant provided the largest percentage of air included in the spray. For the surface tension, the mineral oil and the surfactant had the lowest values. It was concluded that the use of adjuvants had a direct influence on the percentage of air included. In addition, products with greater ability to reduce surface tension and to form homogeneous solutions provided the increase in the percentage of air included in the droplet.
O ar incluído em gotas geradas por pontas de pulverização interfere diretamente em seu transporte e deposição, influenciando também na retenção das mesmas após o impacto no alvo. O objetivo deste trabalho foi verificar a interferência de adjuvantes na quantidade de ar incluído em gotas geradas por pontas de pulverização. Os tratamentos utilizados corresponderam a soluções contendo: óleo mineral, óleo vegetal, surfatante e água, aplicados com três tipos de pontas de pulverização, sendo duas com indução de ar e uma com pré-orifício. O ar incluído foi calculado através da diferença entre o volume da mistura pulverizada (ar mais líquido) e apenas o líquido, que foi feito por meio de amostras pulverizadas, capturadas em um funil e coletadas em proveta graduada. A tensão superficial foi estimada através do método gravimétrico, utilizando uma balança de precisão e uma bureta graduada. O surfatante foi o que proporcionou maior porcentagem de ar incluído na pulverização. Para a tensão superficial, as caldas contendo óleo mineral e o surfatante tiveram os menores valores. Os resultados mostraram que o uso de adjuvantes tem influência direta na porcentagem de ar incluído. Além disso, adjuvantes com maior capacidade de redução da tensão superficial e que formam misturas mais homogêneas proporcionaram aumento da porcentagem de ar incluído nas gotas pulverizadas.

Descrição

Palavras-chave

tecnologia de aplicação, indução de ar, pré-orifício, tensão superficial, application technology, air induction, pre-orifice, surface tension

Como citar

Engenharia Agrícola. Associação Brasileira de Engenharia Agrícola, v. 33, n. 6, p. 1281-1288, 2013.