Multi-layered LiNbO3 films prepared by a polymeric precursor method
Nenhuma Miniatura disponível
Data
2001-01-01
Autores
Bouquet, V
Leite, E. R.
Longo, Elson [UNESP]
Varela, José Arana [UNESP]
Viry, M. G.
Perrin, A.
Título da Revista
ISSN da Revista
Título de Volume
Editor
Elsevier B.V.
Resumo
The polymeric precursor method was used to prepare multi-layered LiNbO3 films. The overall process consists of preparing a coating solution from the Pechini process and the deposited film is subsequently heat-treated. Two-layered films were prepared by this process, onto (0001) sapphire substrates. Two different routes were investigated for the heat-treatment. The amorphous route consisted of performing, after each deposition, a pre-treatment at low temperature to eliminate the organic material. In this case, the crystallization heat-treatment was performed only after the two layers had been deposited. on the other hand, a process layer-after-layer crystallization was used. Both routes led to (0001) LiNbO3 oriented films. However, only the film prepared by the layer-after-layer crystallization presented an epitaxial growth and a crack-free morphology. Moreover, the layer-after-layer crystallization process led to a film exhibiting the best optical properties. (C) 2001 Elsevier B.V. Ltd. All rights reserved.
Descrição
Palavras-chave
films, microstructure-final, niobates, optical properties
Como citar
Journal of the European Ceramic Society. Oxford: Elsevier B.V., v. 21, n. 10-11, p. 1521-1524, 2001.