Projeto de uma roda para comporta vagão usando elementos finitos

Carregando...
Imagem de Miniatura

Data

2006-02

Autores

Correard, Gilvan Cesar de Castro [UNESP]

Título da Revista

ISSN da Revista

Título de Volume

Editor

Universidade Estadual Paulista (Unesp)

Resumo

O objetivo desta pesquisa foi apresentar um método de análise para a solução de problemas de contato por elementos finitos e o cálculo dos componentes mecânicos que fazem parte do projeto de uma roda de aço. Foi demonstrado passo a passo à execução de um cálculo analítico da roda de uma Comporta Vagão, calculando as cargas radial e axial presentes, verificando a tensão de Hertz, as tensões localizadas no cubo da roda, as tensões atuantes no eixo e a seleção do rolamento. Após esta etapa retiraram-se os parâmetros iniciais que foram utilizados no cálculo analítico para buscar o cálculo por elementos finitos. Assim, foram definidas as superfícies de contato, a geometria dos componentes, a malha, as restrições, as condições de contorno e por fim a análise dos resultados encontrados antes e após o projeto. Dessa maneira, podê-se determinar com precisão os pontos de concentração de tensão para eliminação as falhas. Com a busca deste cálculo, usando a análise por Elementos Finitos, respaldado pelo cálculo analítico, foi possível reduzir o diâmetro da roda para obter ganhos em massa para este tipo de equipamento que usa uma quantidade alta de rodas (acima de 100 rodas), sem alteração da confiabilidade das peças durante seu funcionamento.
The objective of this research was to present an analysis method for the solution of contact problems for finite elements and the calculation of the mechanical components that are part of the project of a steel wheel. It was demonstrated step by step the execution of an analytic calculation of the wheel of a Fixed Wheel Gate, calculating the radial and axial loads present, verifying the Hertz pressure, the concentrated stresses in the hub of the wheel, the acting stresses in the shaft and hub, and the selection of the roller bearings. After this stage the initial parameters were used in the analytic calculation in order to obtain the calculation using finite elements. After this, it was defined the contact surfaces, the geometry of the components, the mesh, the restrictions, the real constraints and finally the analysis of the results found before and after the project. After this calculation, the other analysis was established in order to determine the points of concentration stress accurately for the elimination of fails. In order to obtain the calculation, using Finite Elements, by the analytic calculation it was possible to reduce the diameter of the wheel to obtain earn in mass for this type of equipment that uses a high amount of wheels (above 100 wheels), without alteration of the reliability of the parts during the operation.

Descrição

Palavras-chave

Método dos elementos finitos, Rodas de aço, Comportas hidráulicas, Steel wheels, Hydraulic gates

Como citar

CORREARD, Gilvan Cesar de Castro. Projeto de uma roda para comporta vagão usando elementos finitos. 2006. 159 f. Dissertação (mestrado) - Universidade Estadual Paulista, Faculdade de Engenharia de Guaratinguetá, 2006.