Influência da relação entre diâmetros no comportamento hidrodinâmico de reatores aeróbios de leito fluidizado com circulação em tubos concêntricos
Carregando...
Arquivos
Data
2008-11-28
Autores
Araújo, Leandro Santos de [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Universidade Estadual Paulista (Unesp)
Resumo
O reator aeróbio de leito fluidizado com circulação apresenta características que permitem efetuar o tratamento em apenas uma etapa. O uso deste reator torna-se atraente devido à possibilidade de mantê-lo com uma alta concentração de biomassa ativa, propiciando seu porte compacto, conseqüência do reduzido período de detenção hidráulica. A eficiência do biofilme no tratamento depende das condições hidrodinâmicas do reator, uma vez que sua espessura pode ser alterada de acordo com a velocidade de circulação, e a transferência de oxigênio através de suas camadas depende da vazão de ar injetada no sistema. O trabalho propôs-se a investigar a influência da relação entre diâmetros dos tubos concêntricos em quatro configurações, mantendo o diâmetro externo constante e igual a 250 mm e alterando o diâmetro interno entre 100, 125, 150 e 200 mm, proporcionando relações Ae/Ai iguais a 5,25; 3,00; 1,78 e; 0,56, respectivamente. O tubo interno possui 2,22 m e é posicionado 0,05m acima do fundo do reator. A altura estática da coluna de fluido foi 2,35 m. Os ensaios hidrodinâmicos – velocidade do líquido, fração volumétrica de ar, tempo de mistura – e os de transferência de oxigênio foram realizados para vazões de ar até 2500 l/h em meio bifásico e em meio trifásico com concentrações de areia iguais a 30, 70, 100 e 150 g/l. O diâmetro interno de 125 mm foi o mais eficiente na indução de velocidade de circulação do líquido. A fração volumétrica de ar aumentou com o aumento do diâmetro interno para mesmas velocidades superficiais de ar, com exceção do menor diâmetro, o qual apresentou comportamento diferenciado dos demais. Os reator com diâmetro interno de 150 mm apresentou maiores valores de KLa para as mesmas vazões de ar. Observou-se que a adição de sólidos causou um decréscimo da velocidade do líquido e da fração...
Aerobic internal-loop airlift reactor has some characteristics that allow wastewater treatment in a single stage. The attractive to use this kind of reactor is mainly because of its capacity of maintaining a high active biomass concentration into it, which induces its small structure, in a consequence of its small hydraulic detention time. The biofilm efficiency in the treatment depends on reactor’s hydrodynamic conditions. The structure of the biofilm and the oxygen transfer into its layers is affected by the liquid velocity induced by the air flow rate. This work proposed an investigation about the influence of the diameter of the concentric tubes, using four geometric configurations. The model had a 250 mm external tube and the inner draft tube with diameters of 100, 125, 150 and 200 mm, which means AD/AR equals to 5.25, 3.00, 1.78 and 0.56, respectively. The draft tube’s height was 2,22 m and was positioned 0,05 m above the bottom of the reactor. The static fluid height was 2,35 m. The hydrodynamic tests – liquid velocities, gas hold up, mixture time – and the oxygen transfer tests were conducted for two and three-phase systems, with variable air flow rate up to 2500 l/h. The solid phase concentrations used were 30, 70, 100 and 150 g/l. The 125 mm reactor was the most efficient in inducing the liquid circulation velocity. The gas hold up increased with the increasing of the draft tube diameter, for same superficial gas velocities, excepting the 100 mm, which showed a different behavior. The 150 mm reactor presented the highest values for KLa for the same air rate. It was noticed that the solids addiction decreased the liquid velocity, gas hold up and oxygen transfer. Hydrodynamics equations found in literature showed a limited applicability, evidencing the necessity of relations capable to reach the most different configuration for this kind of reactor. A mass transfer mathematic...(Complete abstract click electronic acces below)
Aerobic internal-loop airlift reactor has some characteristics that allow wastewater treatment in a single stage. The attractive to use this kind of reactor is mainly because of its capacity of maintaining a high active biomass concentration into it, which induces its small structure, in a consequence of its small hydraulic detention time. The biofilm efficiency in the treatment depends on reactor’s hydrodynamic conditions. The structure of the biofilm and the oxygen transfer into its layers is affected by the liquid velocity induced by the air flow rate. This work proposed an investigation about the influence of the diameter of the concentric tubes, using four geometric configurations. The model had a 250 mm external tube and the inner draft tube with diameters of 100, 125, 150 and 200 mm, which means AD/AR equals to 5.25, 3.00, 1.78 and 0.56, respectively. The draft tube’s height was 2,22 m and was positioned 0,05 m above the bottom of the reactor. The static fluid height was 2,35 m. The hydrodynamic tests – liquid velocities, gas hold up, mixture time – and the oxygen transfer tests were conducted for two and three-phase systems, with variable air flow rate up to 2500 l/h. The solid phase concentrations used were 30, 70, 100 and 150 g/l. The 125 mm reactor was the most efficient in inducing the liquid circulation velocity. The gas hold up increased with the increasing of the draft tube diameter, for same superficial gas velocities, excepting the 100 mm, which showed a different behavior. The 150 mm reactor presented the highest values for KLa for the same air rate. It was noticed that the solids addiction decreased the liquid velocity, gas hold up and oxygen transfer. Hydrodynamics equations found in literature showed a limited applicability, evidencing the necessity of relations capable to reach the most different configuration for this kind of reactor. A mass transfer mathematic...(Complete abstract click electronic acces below)
Descrição
Palavras-chave
Reatores fluidizados, Hidrodinamica, Reator aeróbio, Transferência de oxigênio, Fluidized bed, Aerobic reactor, Hydrodynamic, Oxygen transfer
Como citar
ARAÚJO, Leandro Santos de. Influência da relação entre diâmetros no comportamento hidrodinâmico de reatores aeróbios de leito fluidizado com circulação em tubos concêntricos. 2008. 177 f. Dissertação (mestrado) – Universidade Estadual Paulista, Faculdade de Engenharia de Ilha Solteira, 2008.