Modeling of piezoelectric energy harvesting considering the dependence of the rectifier circuit

Nenhuma Miniatura disponível

Data

2014-02-01

Autores

Clementino, Marcel Araujo
Reginatto, Romeu
Silva, Samuel da [UNESP]

Título da Revista

ISSN da Revista

Título de Volume

Editor

Abcm Brazilian Soc Mechanical Sciences & Engineering

Resumo

Harvesting energy with piezoelectric materials has been a process of many practical applications in structural health monitoring, either to recharge batteries or feed directly sensors and also electronic devices. In general, the amount of energy provided by a vibration source requires converting the alternating current (AC) to direct current (DC) through rectifier circuits before using it as a power supply of electronic devices. However, modeling the harvesting system, usually a PZT sensor bonded on a cantilever beam and coupled to a rectifier circuit, using the same software package is pointed out by some authors as a drawback to overcome, due to its multidisciplinary requirements, involving topics of both mechanical and electrical engineering. In this sense, the goal of the present paper is describe a comprehensive and simple modeling strategy, which considers a single computational platform and accounts for both the electromechanical model of a clamped piezoelectric beam and the practical energy harvesting circuit, seeking further application when optimizing the entire energy harvesting system. Numerical simulations and experimental tests are performed to illustrate the proposed approach, considering a full-wave diode bridge as the non-controlled rectifier circuit and a resistive load, which are directly connected to the cantilevered piezoelectric beam.

Descrição

Palavras-chave

Energy harvesting, Power electronic, Smart structures, Unified approach

Como citar

Journal Of The Brazilian Society Of Mechanical Sciences And Engineering. Rio De Janeiro Rj: Abcm Brazilian Soc Mechanical Sciences & Engineering, v. 36, n. 2, p. 283-292, 2014.