Publicação: Using a geophone as an actuator to estimate the velocity of leak noise propagation in buried water pipes
Carregando...
Data
Orientador
Coorientador
Pós-graduação
Curso de graduação
Título da Revista
ISSN da Revista
Título de Volume
Editor
Tipo
Artigo
Direito de acesso
Resumo
A common way to pinpoint a leak in a buried plastic water pipe is to use a leak noise correlator. This is performed by using the time delay between two measured signals and the velocity at which such signals travel along the pipe. In this paper, an investigation is carried out into the use of a geophone in reverse, driven by an oscillating voltage. It then acts as a tapping device, exciting the wave responsible for leak noise propagation, when it is attached to an access point to estimate leak noise velocity. Two different ways of exciting the geophone were investigated. Initial tests were conducted in the laboratory to determine the effectiveness of the device in generating a force over a wide frequency range. Field tests were then carried out on a buried pipe test rig and the predominantly fluid-borne wave was generated by the tapping device, that travelled at least 7 m.
Descrição
Palavras-chave
Cross-correlation method, Geophone, Leak detection, Leak velocity estimation
Idioma
Inglês
Como citar
Applied Acoustics, v. 184.
