Middle Electrode in a Vertical Transistor Structure Using an Sn Layer by Thermal Evaporation
Carregando...
Arquivos
Data
2018-05-01
Autores
Nogueira, Gabriel Leonardo [UNESP]
da Silva Ozório, Maiza [UNESP]
da Silva, Marcelo Marques [UNESP]
Morais, Rogério Miranda [UNESP]
Alves, Neri [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
Abstract: We report a process for performing the middle electrode for a vertical field effect transistor (VOFET) by the evaporation of a tin (Sn) layer. Bare aluminum oxide (Al2O3), obtained by anodization, and Al2O3 covered with a polymethylmethacrylate (PMMA) layer were used as the gate dielectric. We measured the electrical resistance of Sn while the evaporation was carried out to find the best condition to prepare the middle electrode, that is, good lateral conduction associated with openings that give permeability to the electric field in a vertical direction. This process showed that 55 nm Sn thick is suitable for use in a VOFET, being easier to achieve optimal thickness when the Sn is evaporated onto PMMA than onto bare Al2O3. The addition of a PMMA layer on the Al2O3 surface modifies the morphology of the Sn layer, resulting in a lowering of the threshold voltage. The values of threshold voltage and electric field, VTH = − 8 V and ETH = 354.5 MV/m respectively, were calculated using an Al2O3 film 20 nm thick covered with a 14 nm PMMA layer as gate dielectric, while for bare Al2O3 these values were VTH = − 10 V and ETH = 500 MV/m. Graphical Abstract: [Figure not available: see fulltext.].
Descrição
Palavras-chave
AL2O3/PMMA, Permeable electrode, Thermal evaporation, Vertical transistor
Como citar
Electronic Materials Letters, v. 14, n. 3, p. 319-327, 2018.