Different surface treatment strategies on etchable CAD-CAM materials: Part 1—Effect on the surface morphology
Nenhuma Miniatura disponível
Data
2022-01-01
Autores
Porto, Thiago Soares
Medeiros da Silva, Italo Guimaraes
de Freitas Vallerini, Bruna [UNESP]
Fernando de Goes, Mario
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
Statement of problem: Polymer-based computer-aided design and computer-aided manufacturing (CAD-CAM) materials have either a high content of ceramic filler particles or a ceramic network structure. Proper etching of these materials is challenging. Therefore, it is relevant to assess different surface etching strategies and morphological alterations as a result of these techniques. Purpose: The purpose of this 2-part in vitro study was to evaluate different etching strategies on the surface roughness and its relationship to the surface contact angle with a subsequent morphological characterization of different CAD-CAM materials. Material and methods: Two CAD-CAM polymer-based materials and 1 CAD-CAM ceramic material were selected for this study. The materials were treated with different strategies, including a combination of airborne-particle abrasion and an application of 9% hydrofluoric acid etching. After the surface treatment, roughness measurements (Sa) were assessed by using an optical profilometer on an area of 1.47 mm2. Subsequently, the contact angle on the surface was examined by means of the sessile drop technique and an optical contact angle meter. The data were analyzed by using a 2-way analysis of variance, the post hoc Tukey test (α=.05), and the Pearson correlation coefficient. Results: The 3 materials tested showed an increase in surface roughness when treated with surface airborne-particle abrasion. However, the materials with polymer in their composition concomitantly increased the contact angle. More hydrophilic surfaces were observed when hydrofluoric acid was applied, regardless of the composition of the materials. The surface roughness presented a strong positive linear tendency in the surface treatments used. Conclusions: The application of airborne-particle abrasion on the surface of the polymer-based CAD-CAM materials increased the roughness and contact angle. However, the application of acid etching after the airborne-particle abrasion decreased the contact angle for polymer-based CAD-CAM materials, resulting in considerable enhancement of the surface quality for proper bonding.
Descrição
Palavras-chave
Como citar
Journal of Prosthetic Dentistry.