The effectiveness of alumina powder on carious dentin removal
Nenhuma Miniatura disponível
Data
2006-05-01
Autores
Motisuki, C.
Lima, L. M.
Bronzi, E. S.
Spolidório, Denise Madalena Palomari [UNESP]
Santos-Pinto, Lourdes Aparecida Martins dos [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Operative Dentistry Inc
Resumo
This study determined the size of aluminum oxide particles used in an air abrasion system that is able to remove carious dentin tissue with maximum preservation of sound structure. Thirty extracted and carious-free third molars were used in this study. The dentin sample was obtained by sectioning the middle of the crown longitudinal to the long axis of the tooth in a mesio-distal direction. One half of the crown corresponded to the sound dentin group (SD), while the other half was used to develop artificial caries, constituting the, carious dentin group (CD). The specimens were air abraded for 15 seconds. The SD and CD groups were each randomly divided into three subgroups (N=10) according to the particle diameter employed (27, 50 and 125 pm). The prepared cavity was perpendicularly cut in half, and the profiles of all hemi-fragments were observed using SEM microscopy. The cavity measurements were made using a modified cephalometric analysis. The 27, 50 and 125 pun aluminum oxide particles did not present selectivity in the removal of carious dentin. However, when using the air abrasive technique for carious dentin treatment, the use of 27 and 50 pun aluminum oxide particles is recommended, due to their capacity to remove less sound tissue than the 125 pun particles.
Descrição
Palavras-chave
Como citar
Operative Dentistry. Indianapolis: Operative Dentistry Inc., v. 31, n. 3, p. 371-376, 2006.