Structural analyzes of the use of residues of tires in reinforced concrete
Nenhuma Miniatura disponível
Data
2004-12-01
Autores
Akasaki, J. L. [UNESP]
França, V. H. [UNESP]
Barbosa, M. P. [UNESP]
Salles, F. M.
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
The search for an adequate destination to the tires without use is a problem for many countries. The use of tire rubber in concrete through the partial substitution of the small aggregate has for objective the withdrawal of this material of the environment besides serving as alternative material in places that present sand scarcity. However, to use this type of concrete in civil construction it's necessary to verify its structural behavior. The behavior of the adherence enters the bar of armor and the concrete surrounding it has decisive importance with relation to the load capacity of the structures of reinforced concrete. In this context, this work presents, argues and evaluates the results of the experimental studies for determination of the adherence tension according to pulling up assays pull-out normalized for CEB RC6 and also related in the ASTM C-234 in concrete with and without rubber residues. Armors of nominal diameter of 10,0; 12,5 and 16 mm had been used and concrete contend 10% of rubber fibres in substitution to the sand in volume.
Descrição
Palavras-chave
Adherence steel-concrete, Concrete with tire, Tire fiber, Aggregates, Dynamic loads, Reinforced concrete, Sand, Structural analysis, Tires, Waste management
Como citar
Proceedings of the International Conference on Sustainable Waste Management and Recycling: Used/Post-Consumer Tyres, p. 143-150.