De Assis Andrade Barbosa, Francisco [UNESP]Takiy, Aline Emy [UNESP]Higuti, Ricardo Tokio [UNESP]Carbonari, Ronny CalixtoKitano, Cláudio [UNESP]Silva, Emílio Carlos Nelli2014-05-272014-05-272010-12-012010 9th IEEE/IAS International Conference on Industry Applications, INDUSCON 2010.http://hdl.handle.net/11449/72051The class of piezoelectric actuators considered in this paper consists of a multi-flexible structure actuated by two or more piezoceramic devices that must generate different output displacements and forces at different specified points of the domain and in different directions. The devices were modeled by finite element using the software ANSYS and the topology optimization method. The following XY actuators were build to achieve maximum displacement in the X and Y directions with a minimum crosstalk between them. The actuator prototypes are composed of an aluminum structure, manufactured by using a wire Electrical Discharge Machining, which are bonded to rectangular PZT5A piezoceramic blocks by using epoxy resin. Multi-actuator piezoelectric device displacements can be measured by using optical interferometry, since it allows dynamic measurements in the kHz range, which is of the order of the first resonance frequency of these piezomechanisms. A Michelson-type interferometer, with a He-Ne laser source, is used to measure the displacement amplitudes in nanometric range. A new optical phase demodulation technique is applied, based on the properties of the triangular waveform drive voltage applied to the XY piezoelectric nanopositioner. This is a low-phase-modulation-depth-like technique that allows the rapid interferometer auto-calibration. The measurements were performed at 100 Hz frequency, and revealed that the device is linear voltage range utilized in this work. The ratio between the generated and coupled output displacements and the drive voltages is equal to 10.97 nm/V and 1.76 nm/V, respectively, which corresponds to a 16% coupling rate. © 2010 IEEE.engAluminum structuresAuto calibrationCoupling rateDisplacement amplitudesDrive voltageDynamic measurementFinite ElementHe-Ne lasersMaximum displacementMichelson-type interferometersMulti-actuated piezoelectric devicesNano-positionerNanometric rangesOptical interferometryOptical phasePiezoceramicPiezoceramic devicesResonance frequenciesSoftware ANSYSTopology Optimization MethodTriangular waveformVoltage rangesWire electrical discharge machiningElectric discharge machiningElectric dischargesEpoxy resinsFinite element methodFlexible structuresInterferometersInterferometryNeonOptimizationPiezoelectricityResinsResonancePiezoelectric actuatorsCoupling rate measurement of a novel multi-actuated piezoelectric device using optical interferometryTrabalho apresentado em evento10.1109/INDUSCON.2010.5740065Acesso aberto2-s2.0-79955139713640533951088320328834403518951670000-0003-4201-56170000-0001-6320-755X