Jorge, André Luiz Cervantesde Araújo, Maria Amélia Máximo2014-05-272014-05-272007-03-01Quintessence international (Berlin, Germany : 1985), v. 38, n. 3, 2007.0033-6572http://hdl.handle.net/11449/69572OBJECTIVE: To evaluate the influence of cavity design and photocuring method on the marginal seal of resin composite restorations. METHOD AND MATERIALS: Seventy-two bovine teeth were divided into 2 groups: group 1 received box-type cavity preparations, and group 2 received plate-type preparations. Each group was divided into 3 subgroups. After etching and bonding, Z250 resin composite (3M Espe) was applied in 2 equal increments and cured with 1 of 3 techniques: (1) conventional curing for 30 seconds at 650 mW/cm2; (2) 2-step photocuring, in which the first step was performed 14 mm from the restoration for 10 seconds at 180 mW/cm2 and the second step was performed in direct contact for 20 seconds at 650 mW/cm2; or (3) progressive curing using Jetlite 4000 (J. Morita) for 8 seconds at 125 mW/cm2 and then 22 seconds at 125 mW/cm2 up to 500 mW/cm2. The specimens were thermocycled for 500 cycles and then submitted to dye penetration with a 50% silver nitrate solution. Microleakage was assessed using a stereomicroscope. Data were analyzed using analysis of variance and Tukey test (5% level of significance). RESULTS: A statistically significant difference was found between groups when a double interaction between photocuring and cavity preparation was considered (P = .029). CONCLUSIONS: No one type of cavity preparation or photocuring method prevented micro-leakage. The plate-type preparation showed the worst dye penetration when conventional and progressive photocuring methods were used. The best results were found using the 2-step photocuring with the plate-type preparation.engacrylic acid resinComposite Dental Resinpolyurethanresinunclassified druganimalcattlechemistrydental surgeryendodonticsmethodologyradiation exposuretooth diseaseAcrylic ResinsAnimalsCattleComposite ResinsDental Cavity PreparationDental LeakageMarginal Adaptation (Dentistry)PolyurethanesArtigoAcesso restrito2-s2.0-34648831999