Vazão e uniformidade de distribuição de tubo gotejador em superfície e subsuperfície
Carregando...
Arquivos
Data
2017-02-21
Autores
Reis, Karoline Maso dos [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Universidade Estadual Paulista (Unesp)
Resumo
A caracterização da distribuição de água por tubo gotejador é imprescindível para a irrigação. E, a falta de conhecimento desse fator leva a impactos econômicos e ambientais. O objetivo deste trabalho foi avaliar a uniformidade de distribuição e vazão de um tubo gotejador em condição de irrigação superficial e subsuperficial. Utilizou-se o tubo gotejador Drip Net PCTM AS 16150, com delineamento experimental no esquema fatorial 5 x 5, com quatro repetições. Os tratamentos foram constituídos da combinação de 5 profundidades de submersão do tubo gotejador (0; 10; 20; 30 e 40 cm) e 5 pressões de entrada da água no tubo gotejador (49, 98, 147, 196 e 245 kPa). O menor coeficiente de uniformidade de distribuição obtido foi de 95,55% e o menor coeficiente de uniformidade de Christiansen, 96,37%, sendo classificados como excelentes de acordo com Merriam e Keller (1978) e Mantovani (2002), respectivamente. O coeficiente de variação de fabricação ficou dentro da regulamentação, ABNT NBR ISO 9261, sendo menor que 7%. As vazões em subsuperfície apresentaram-se mais próximas da vazão nominal do tubo gotejador do que a vazão em superfície, indicando bom desempenho do tubo gotejador para irrigação em subsuperfície.
The characterization of the water distribution by dripping tube is essential for irrigation. And, lack of knowledge of this factor leads economic and environmental impacts. The objective of this research was to evaluate the uniformity of distribution and flow of a dripper tube in surface and subsurface irrigation conditions. The Drip Net PCTM AS dripping tube 16150 was used, with experimental design in a 5 x 5 factorial scheme, with four replications. The treatments consisted of the combination of 5 submersion depths of the dripper tube (0, 0.1, 0.2, 0.3 and 0.4 m) and 5 inlet pressures of the water in the dripper tube (49, 98, 147, 196 and 245 kPa). The lowest coefficient of uniformity of distribution was 95.55% and the lowest coefficient of uniformity of Christiansen, 96.37%, being classified as excellent according to Merriam and Keller (1978) and Mantovani (2002), respectively. The coefficient of variation of manufacturing was within the regulation, ABNT NBR ISO 9261, being less than 7%.The subsurface flow rates were closer to the nominal flow rate of the dripping tube than to the surface flow rate, indicating a good performance of the drip tube in subsurface.
The characterization of the water distribution by dripping tube is essential for irrigation. And, lack of knowledge of this factor leads economic and environmental impacts. The objective of this research was to evaluate the uniformity of distribution and flow of a dripper tube in surface and subsurface irrigation conditions. The Drip Net PCTM AS dripping tube 16150 was used, with experimental design in a 5 x 5 factorial scheme, with four replications. The treatments consisted of the combination of 5 submersion depths of the dripper tube (0, 0.1, 0.2, 0.3 and 0.4 m) and 5 inlet pressures of the water in the dripper tube (49, 98, 147, 196 and 245 kPa). The lowest coefficient of uniformity of distribution was 95.55% and the lowest coefficient of uniformity of Christiansen, 96.37%, being classified as excellent according to Merriam and Keller (1978) and Mantovani (2002), respectively. The coefficient of variation of manufacturing was within the regulation, ABNT NBR ISO 9261, being less than 7%.The subsurface flow rates were closer to the nominal flow rate of the dripping tube than to the surface flow rate, indicating a good performance of the drip tube in subsurface.
Descrição
Palavras-chave
Irrigação localizada, Contrapressão, Manejo de irrigação, Localized irrigation, Backpressure, Irrigation management