Caracterização hidráulica e técnica de tubos emissores não regulados
Nenhuma Miniatura disponível
Data
2015-01-01
Autores
Dalri, Alexandre Barcellos [UNESP]
Garcia, Carlos Jesus Baca
Palaretti, Luiz Fabiano [UNESP]
Zanini, José Renato [UNESP]
de Faria, Rogério Teixeira [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
This study aims to characterize and evaluate seven models of turbulent flow nonselfcompensating drippers available in the Brazilian market. The characterization of the emitters followed the procedures of the standards NBR ISO 9261. The experiment was conducted at UNESP University Estadual Paulista, Botucatu Campus, Department of Rural Engineering. For the execution of the test one randomly took from each coil, segments containing 25 emitters. In the evaluation of hydraulic and technical characteristics of emitters were determined the following parameters: coefficient of manufacturing variation, coefficients of the characteristic equation of the emitter, thickness of the tube wall, internal diameter, spacing between emitters, water pressure resistance at ambient temperature and 40 ºC, the tensile strength of the tube with a tension of 160 N and 180 N, and premature aging testing. The analysis of the drip tapes showed a coefficient of manufacturing variation of less than 0.056 for all emitters. The exponents (m) of the equation pressure versus flow rate ranged from 0.431 to 0.575, classifying them as nonself-compensating. About the wall thickness, the internal diameter of the drip tapes and the spacing between emitters were found out that all measured values are within the required standard. From the results obtained, it can be stated that all products tested and available in the Brazilian market showed satisfactory performance and quality.
Descrição
Palavras-chave
Drip, Evaluation, NBR ISO 9261
Como citar
Revista Caatinga, v. 28, n. 4, p. 161-169, 2015.