Comparison of methanol/hydrochloric, ferric chloride acid versus tribochemical silica coating for adhesion of resin cement to zirconium dioxide
Carregando...
Arquivos
Data
2016-12-16
Autores
de Carvalho, Rodrigo Furtado
Özcan, Mutlu
Louzada, Frederico [UNESP]
Monteiro, Evelyn [UNESP]
Bottino, Marco Antonio [UNESP]
de Melo, Renata Marques [UNESP]
Valandro, Luiz Felipe
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
This study compared air-abrasion and etching regimens on adhesion of resin luting agent to zirconium dioxide. Ceramic specimens (LAVA, 3 M ESPE) (N = 16) were embedded in acrylic resin and exposed surfaces were polished. The specimens were randomly assigned into four groups (n = 12, 3 specimens for each disc): SC: Air-borne particle abrasion (30 μm aluminum oxide particles coated with silica, CoJet, 3 M ESPE); MH: Heated chemical solution (Methanol-800 mL; 37% Hydrochloric Acid-200 mL; Ferric Chloride-2 g) at 100 °C for 30 min, MHP: Primer (Metal/Zirconia Primer, Ivoclar Vivadent) + MH, P: Primer only (Metal/Zirconia Primer). Cylindrical molds (internal diameter: 0.7 mm; height: 1.5 mm) were placed on each conditioned specimen, filled with resin cement (Multilink Automix) and photo-polymerized for 60 s. After 24 h, the molds were removed and the specimens were stored in distilled water at 37 °C for six months). Microshear test was performed in a Universal Testing Machine (1 mm/min). Failures types were classified as adhesive, mixed, or cohesive. In another set of specimens (n = 2 per group) contact angle measurements were recorded. Data were analyzed statistically using Kruskal–Wallis and Dunn’s tests (α = 0.05). The surface conditioning method significantly affected the mean bond strength (MPa) (p < 0.0001): SC(18.3 ± 0.3)a < P(5.00 ± 0.07)b < MHP(4.7 ± 0.08)c < MH(0.84 ± 0.01)c. While Group SC showed mainly adhesive (58%) and mixed (41.7%) failure types, groups MH, MHP, and P presented exclusively adhesive failures. SC, MHP, and P (29–32°) showed lower contact angle than MH (78.9°). Volume loss was the highest with MHP (9.92 μl) followed by SC (9.67 μl).
Descrição
Palavras-chave
Adhesion, air-abrasion, cementation, ceramics, etching, microshear bond test, surface conditioning, zirconia
Como citar
Journal of Adhesion Science and Technology, v. 30, n. 24, p. 2690-2698, 2016.