Nanohardness of a Ti thin film and its interface deposited by an electron beam on a 304 SS substrate
Nenhuma Miniatura disponível
Data
2002-07-01
Autores
Vieira, R. A.
Nono, MCA
Cruz, N. C.
Título da Revista
ISSN da Revista
Título de Volume
Editor
Wiley-Blackwell
Resumo
The results of nanohardness measurements at a film surface and film-substrate interface are presented and discussed. An electron beam device was used to deposit a Ti film on a 304 stainless steel (304 SS) substrate. The diluted interface was obtained by thermal activated atomic diffusion. The. Ti film and Ti film-304 SS interface were analyzed by energy dispersive spectrometry and were observed using atomic force microscopy. The nanohardness of the Ti film-304 SS system was measured by a nanoindentation technique. The results showed the Ti film-304 SS interface had a higher hardness value than the Ti film and 304 SS substrate. The Ti film surface had a lower hardness due to the presence of a TiO2 thin layer.
Descrição
Palavras-chave
Como citar
Physica Status Solidi B-basic Research. Weinheim: Wiley-v C H Verlag Gmbh, v. 232, n. 1, p. 116-120, 2002.