Exploring potentialities of the HR-CS FAAS technique in the determination of Ni and Pb in mineral waters
Nenhuma Miniatura disponível
Data
2008-01-01
Autores
Filho, V. R. Amorim [UNESP]
Franzini, V. P. [UNESP]
Neto, J. A. Gomes [UNESP]
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
National Health Surveillance Agency (ANVISA) established in the decree number 54 maximum allowed levels for Ni and Pb in mineral and natural waters at 20 μg L-1 and 10 μg L-1, respectively. For screening analysis purposes, the high-resolution continuum source flame atomic absorption spectrometry technique (HR-CS FAAS) was evaluated for the fast-sequential determination of nickel and lead in mineral waters.Two atomic lines for Ni (232.003 nm - main and 341.477 nm - secondary) and Pb (217.0005 nm - main and 283.306 nm - secondary) at different wavelength integrated absorbance (number of pixels) were evaluated. Sensitivity enhanced with the increase of the number of pixels and with the summation of the atomic lines absorbances. The main figures of merit associated to the HR-CS FAAS technique were compared with that obtained by line-source flame atomic absorption spectrometry (LS FAAS). Water samples were pre-concentrated about 5-fold by evaporation before analysis. Recoveries of Pb significantly varied with increased wavelength integrated absorbance. Better recoveries (92-93%) were observed for higher number of pixels at the main line or summating the atomic lines (90-92%). This influence was irrelevant for Ni, and recoveries in the 92- 104% range were obtained in all situations.
Descrição
Palavras-chave
HR-CS FAAS, Mineral water, Ni, Pb, Screening analysis
Como citar
Ecletica Quimica, v. 33, n. 1, p. 49-56, 2008.