Publicação: Análise do comportamento da microestrutura de materiais endurecidos retificados com rebolos de CBN
Carregando...
Data
2000-10
Orientador
Coorientador
Pós-graduação
Curso de graduação
Título da Revista
ISSN da Revista
Título de Volume
Editor
ABM, ABC, ABPol
Tipo
Artigo
Direito de acesso
Acesso aberto
Resumo
CBN grinding wheels are superabrasive tools, with cutting ability higher than the conventional ones, specially used for grinding DTG (Difficult to Grind) materials. Due to the higher hardness and thermal conductivity of the CBN superabrasive grains, when compared with conventional abrasive grains, the use of CBN tools reduce the grinding temperatures decreasing the probability of workipece’s thermal damage. These proprieties of CBN grains permit lowering the energy partition because less heat is generated during grinding and much heat is dissipated through the grinding wheel instead of through the workpiece. This paper shows a research about the microstructural changes in the ground subsurface and the differences in the superficial integrity when using two types of superabrasive grinding wheels, manufactured with vitrified and resin bonds, analyzed in different cutting conditions. The ground material was the VC 131 steel, hardened and tempered. Were not observed microstructural changes in the subsurface ground with the two types of tools. As a result, the use of different types of the bonding do not affect the surface integrity neither resulted in microstructural changes, because the maximum temperatures measured in the grinding zone were lower than 125 °C, much less than the required level to cause microstructural changes.
Descrição
Palavras-chave
Idioma
Português
Como citar
Materials Research. São Carlos, SP, Brazil: ABM, ABC, ABPol, v. 3, n. 4, p. 147-154, 2000.
