Publicação: Exterior orientation of hyperspectral frame images collected with UAV for forest applications
Carregando...
Arquivos
Data
Autores
Orientador
Coorientador
Pós-graduação
Curso de graduação
Título da Revista
ISSN da Revista
Título de Volume
Editor
Tipo
Trabalho apresentado em evento
Direito de acesso
Acesso aberto
Resumo
This paper describes a preliminary study on the image orientation acquired by a hyperspectral frame camera for applications in small tropical forest areas with dense vegetation. Since access to the interior of forests is complicated and Ground Control Points (GCPs) are not available, this study conducts an assessment of the altimetry accuracy provided by control targets installed on one border of an image block, simulating it outside a forest. A lightweight Unmanned Aerial Vehicle (UAV) was equipped with a hyperspectral camera and a dual-frequency GNSS receiver to collect images at two flying strips covering a vegetation area. The assessment experiments were based on Bundle Block Adjustment (BBA) with images of two spectral bands (from two sensors) using several weighted constraints in the camera position. Trials with GCPs (presignalized targets) positioned only on one side of the image block were compared with trials using GCPs in the corners. Analyses were performed on altimetry discrepancies obtained from altimetry checkpoints. The results showed a discrepancy in Z coordinate of approximately 40 cm using the proposed technique, which is sufficient for applications in forests.
Descrição
Palavras-chave
Forest, Hyperspectral image, Orientation, Sparse control, UAV
Idioma
Inglês
Como citar
International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences - ISPRS Archives, v. 40, n. 3W4, p. 45-50, 2016.
