Biodiesel Processing Using Sodium and Potassium Geopolymer Powders as Heterogeneous Catalysts
Nenhuma Miniatura disponível
Data
2020-06-01
Autores
Botti, Renata F.
Innocentini, Murilo D.M.
Faleiros, Thais A.
Mello, Murilo F.
Flumignan, Danilo L. [UNESP]
Santos, Leticia K. [UNESP]
Franchin, Giorgia
Colombo, Paolo
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
This work investigates the catalytic activity of geopolymers produced using two different alkali components (sodium or potassium) and four treatment temperatures (110 to 700 °C) for the methyl transesterification of soybean oil. The geopolymers were prepared with metakaolin as an aluminosilicate source and alkaline activating solutions containing either sodium or potassium in the same molar oxide proportions. The potassium-based formulation displayed a higher specific surface area and lower average pore size (28.64–62.54 m2/g; 9 nm) than the sodium formulation (6.34–32.62 m2/g; 17 nm). The reduction in specific surface area (SSA) after the heat treatment was more severe for the sodium formulation due to the higher thermal shrinkage. The catalytic activity of the geopolymer powders was compared under the same reactional conditions (70–75 °C, 150% methanol excess, 4 h reaction) and same weight amounts (3% to oil). The differences in performance were attributed to the influences of sodium and potassium on the geopolymerization process and to the accessibility of the reactants to the catalytic sites. The Na-based geopolymers performed better, with FAME contents in the biodiesel phase of 85.1% and 89.9% for samples treated at 500 and 300 °C, respectively. These results are competitive in comparison with most heterogeneous base catalysts reported in the literature, considering the very mild conditions of temperature, excess methanol and catalyst amount and the short time spent in reactions.
Descrição
Palavras-chave
Alkali, Biodiesel, Geopolymer, Heterogeneous catalyst, Transesterification
Como citar
Molecules, v. 25, n. 12, 2020.