Formation and characterization of soy bean oil/surfactant/water microemulsions
Nenhuma Miniatura disponível
Data
2006-06-15
Autores
Polizelli, Marcos Alexandre
Telis, Vania Regina Nicoletti
Amaral, Lia Q.
Feitosa, Eloi
Título da Revista
ISSN da Revista
Título de Volume
Editor
Elsevier B.V.
Resumo
Pseudoternary phase diagrams, at 25 degrees C, were constructed for the systems soy bean oil (SBO)/surfactant/water, with single anionic sodium bis(2-ethylhexyl)sulfosuccinate (AOT), nonionic monoolein (MO) and mixtures of these surfactants, showing the isotropic phase of W/O microemulsions (MEs). The area of ME formation in the phase diagrams was shown to be dependent of the relative amount of surfactants, being larger for MO:AOT equals to 2:1. Rheological and dynamic light scattering (DLS) studies indicated that the viscosity of the isotropic ME phase exhibited two different behaviors depending on composition. The viscosity of dry MEs initially decreased with increasing amount of water following a dilution line in the phase diagram, i.e., a constant surfactant:SBO percentage ratio. As the water content increased the relative viscosity attained a minimum and then increased. This minimum could be related to the transition between two ME regions, L-2 and L'(2), having different characteristics. DLS measurements confirm the existence of ordinary W/O ME droplets in the L-2 region and suggest the existence of another structure in the L'(2) region. The size of the MEs droplets in L-2 phase ranges from 3.6 to 16.5 nm, depending on composition of SBO, surfactant and water. Small angle X-ray scattering (SAXS) also indicates the existence of structures with different characteristics, for the SAXS curves exhibit a typical micelle asymmetrical peak at low scattering vector q for MEs in L-2 but a symmetrical correlation peak at higher q vector in L'(2). (c) 2006 Elsevier B.V. All rights reserved.
Descrição
Palavras-chave
microemulsions, reverse micelles, dry micelles, phase diagram, Soybean oil, surfactant, Rheology, scattering techniques
Como citar
Colloids and Surfaces A-physicochemical and Engineering Aspects. Amsterdam: Elsevier B.V., v. 281, n. 1-3, p. 230-236, 2006.