Experimental Investigation of Parameters Impacting the Roughness of Pinus elliottii Wood

Nenhuma Miniatura disponível

Data

2019-01-01

Orientador

Coorientador

Pós-graduação

Curso de graduação

Título da Revista

ISSN da Revista

Título de Volume

Editor

North Carolina State Univ Dept Wood & Paper Sci

Tipo

Artigo

Direito de acesso

Acesso restrito

Resumo

The wood sanding process entails a small reduction in the dimensions of the workpiece in the course of modifying its surface morphology, which affects the aesthetics and the subsequent application of a coating. However, sanding is costly, partly because it is performed empirically without standardization. Therefore, this study analyzed the influence of sandpaper factors on the behavior of wood surface roughness for Pinus elliottii. A complete factorial experiment was performed, varying two types of abrasives, aluminum oxide and silicon carbide, in three grit sizes (80, 100, and 120), and three sandpaper conditions (new, semi-new, and worn). The tests were performed using a flat sander with a pneumatic circuit and monitoring system for data acquisition, which were analyzed through multiple Tukey tests. The results were organized in a consultation table that compared the combination of factors analyzed, informing whether they produced roughness of the wood equal to or distinct from each other. The results showed that new aluminum oxide sandpapers with grit sizes of 80, 100, and 120 produced roughness of the wood different from each other, while the carbide did not. Therefore, there is no need to trade or buy silicon carbide sandpaper in these grit sizes.

Descrição

Idioma

Inglês

Como citar

Bioresources. Raleigh: North Carolina State Univ Dept Wood & Paper Sci, v. 14, n. 1, p. 2051-2061, 2019.

Itens relacionados

Financiadores