Publicação: Effect of the addition of functionalized TiO2 nanotubes and nanoparticles on properties of experimental resin composites
Carregando...
Data
Orientador
Coorientador
Pós-graduação
Curso de graduação
Título da Revista
ISSN da Revista
Título de Volume
Editor
Elsevier B.V.
Tipo
Artigo
Direito de acesso
Resumo
Objective. To evaluate the influence of the addition of functionalized and non-functionalized TiO2 nanostructures on properties of a resin composite. Methods. TiO2 nanostructures were synthesized and functionalized, using 3(aminopropyl)triethoxysilane (APTMS) and 3-(trimethoxysilyl)propyl methacrylate (TSMPM). Characterizations were performed with XRD, EDS, TEM, and TGA. Resin composites containing Bis-GMA/TEGDMA, CQ, DABE, and barium-aluminum silicate glass were produced according to TiO2 nanostructure (nanotube or nanoparticle), concentration (0.3 or 0.9 wt%), and functionalization (APTMS or TSMPM). The resin composite without nanostructures was used as control. The amount of fillers was kept constant at 78.3 wt% for all materials. The degree of conversion (DC at 0 h and 24 h), maximum polymerization rate (Rp(max)), and Knoop microhardness (KHN before and after ethanol softening) were evaluated. Data were analyzed with two-way ANOVA with repeated measures and Tukey's HSD (a = 0.05). Results. TGA results demonstrated that functionalizations were effective for both nanostructures. For DC, resin composites, time and interaction effect were significant (p < 0.001). Higher DC was found for 0.3-wt%-functionalized-nanotubes at 24 h. For nanoparticles, only 0.9-wt%-non-functionalized and 0.3-wt%-APTMS-functionalized showed DC similar to the control and all other groups showed higher DC (p < 0.05). Rpmax was higher for 0.3-wt%APTMS-nanotubes, which corresponded to higher DC after 24 h. The lowest Rpmax occurred for 0.9-wt%-TSMPM-nanotubes, which showed smaller DC at 0 h. For KHN, resin composites, ethanol softening and interaction effect were significant (p < 0.001). KHN decreased after ethanol softening all groups, except for 0.3-wt%-TSMPM-nanotubes, 0.9-wt%-TSMPMnanotubes, and 0.3-wt%-non-functionalized-nanoparticles. Conclusion. The resin with 0.3-wt%-TSMPM-nanotubes showed higher DC after 24 h, while being the most stable material after the ethanol softening. Significance. The addition of functionalized TiO2 nanostructures in resin-based materials may improve the properties of the material. (C) 2020 The Academy of Dental Materials. Published by Elsevier Inc. All rights reserved.
Descrição
Palavras-chave
Titanium dioxide, Nanostructures, Functionalization, Polymer structure, Methacrylates
Idioma
Inglês
Como citar
Dental Materials. Oxford: Elsevier Sci Ltd, v. 36, n. 12, p. 1544-1556, 2020.
