Filtro de areia portátil para pequenos sistemas de irrigação por gotejamento
Nenhuma Miniatura disponível
Data
2016-01-01
Autores
de Oliveira, Cleomar Ferreira
Teixeira, Marconi Batista
Ramos, Adriana
da Silva, Renato Moreira
Ribeiro, Pedro Henrique Pinto [UNESP]
Frizzone, José Antônio
Título da Revista
ISSN da Revista
Título de Volume
Editor
Resumo
Filters in drip irrigation systems are fundamental to ensure effective control of water quality and to reduce clogging of emitters. Current study aims at constructing a low cost portable sand filter for small localized irrigation systems (up to 1.0 ha) and at determining its head loss due to flow. Tests were carried out in the Hydraulic Laboratory of Biosystems Engineering Department of Agriculture School “Luiz de Queiroz”, University of São Paulo. Magnetic-induction Conaut Krohne model IFS 4000 w/6 with IFC 090 D signal convert of discharge, reading range between 0 and 90 m3.h-1 and 99% precision, was used for flow rate measurements. Pressure loss at each observation point was determined indirectly by two differential pressure gauges with a mercury column. A set of 20 flow readings was performed in three replications. Results showed that maximum filter discharge complied with ASAE guidelines and the cost of materials for manufacture of the filter was U$ 382.15. Linear mathematical model adequately describes the loss of pressure of the sand filter due to flow variation. Rates of minimum and maximum flow recommended range between 0.0257 m3.h-1 and 0.556 m3.h-1, and thus may satisfy small trickle irrigation projects.
Descrição
Palavras-chave
Filtration, Flow rate, Head loss, Water quality
Como citar
IRRIGA, v. 21, n. 1, p. 90-103, 2016.