Effect of alternative sonochemical treatment on zirconia surface and bond strength with veneering ceramic
Nenhuma Miniatura disponível
Data
2020-02-01
Autores
Bastos, Natalia Almeida
Lisboa-Filho, Paulo Noronha [UNESP]
Tabata, Americo [UNESP]
Silveira Francisconi, Paulo Afonso
Furuse, Adilson Yoshio
Honorio, Heitor Marques
Sanches Borges, Ana Flavia
Título da Revista
ISSN da Revista
Título de Volume
Editor
Elsevier B.V.
Resumo
The morphological characterization of sonochemical treatment on bond strength of Y-TZP/veneer ceramic was evaluated. The surface topography and roughness were analyzed by Confocal Laser Scanning Microscopy, Atomic Force Microscopy and Scanning Electron Microscopy. The phase transformation was identified through Micro-Raman Spectroscopy. The specimens were subjected to the Shear Bond Strength (SBS) test. Failure modes were classified and examined by Fractographic analysis. No differences were observed between the groups regarding surface roughness. The C (control) and AOX (sandblasting) groups presented the highest median SBS values, which were significantly different from S40 (sonication with 40% nominal power) which showed the lowest median SBS value. All specimens exhibited phase transformation. Most specimens exhibited mixed failures. Although the alternative sonochemical treatment did not lead to sufficient bond strength at Y-TZP/veneer ceramic, it caused less damage to the ceramic surface than sandblasting. Therefore, only liner use seemed to be better than adding the sonochemical treatment.
Descrição
Palavras-chave
Y-TZP ceramic, Air abrasion, dental, Ceramics, Microscopy, Spectrum analysis, Raman
Como citar
Materials Science And Engineering B-advanced Functional Solid-state Materials. Amsterdam: Elsevier, v. 252, 9 p., 2020.