Flexural strength of a pressable lithium disilicate ceramic: influence of surface treatments
Nenhuma Miniatura disponível
Data
2013-01-01
Orientador
Coorientador
Pós-graduação
Curso de graduação
Título da Revista
ISSN da Revista
Título de Volume
Editor
Tipo
Artigo
Direito de acesso
Resumo
The aim of this paper was to evaluate the influence of different surface treatments on the flexural strength of a pressable lithium disilicate ceramic. Sixteen bars (16x2x4 mm) were made, divided into subgroups (n = 10), and the following surface treatments were done: C - no treatment; H - etching with 5% hydrofluoric acid; HC - etching with 5% hydrofluoric acid, silanization, and cementation; N – etching with 5% hydrofluoric acid, neutralization with supersaturated solution of sodium bicarbonate, silanization, and cementation; U – etching with 5% hydrofluoric acid, ultrasonic cleaning in distillated water, silanization, and cementation; NU - etching with 5% hydrofluoric acid, neutralization with supersaturated solution of sodium bicarbonate, ultrasonic cleaning in distillated water, silanization and cementation. The three points flexural strength was performed 24 h after cementation and the data were analyzed using one-way ANOVA and Tukey’s tests (p-value = 0.05). The results showed that the surface treatment had a significant effect (p-value < 0,05) on the flexural strength of the studied ceramic. The N and NU groups showed lower flexural strength than other groups. Thus, it was concluded that neutralization with supersaturated solution of sodium bicarbonate, followed or not by ultrasonic cleaning results in lower mechanical strength of a pressable lithium disilicate ceramic. The etching with 5% hydrofluoric acid did not reduce the flexural strength of this ceramic type.
Descrição
Palavras-chave
Idioma
Inglês
Como citar
Applied Adhesion Science, v. 1, n. 1, 2013.
